In modern automobile life, the use of electronic toll collection system (ETC) is becoming more and more popular. The advantage of ETC is that it is fast and convenient, and can significantly reduce the queuing time at highway toll gates. For car owners, it is not complicated to install ETC, which is provided belowCrashandburnps2A detailed step-by-step guide for vehicle installation of ETC is provided:
# preparation
First of all, car owners need to go to ETC service points or government-designated banks to apply for ETC cards, which usually involve some registration procedures and fees. At the same time, car owners need to prepare the following materials:
-vehicle driving permit
-proof of identity of the owner
-vehicle photos
# obtain ETC device
After selecting the ETC equipment suitable for the model, the staff will assist the car owner to install the ETC card reader, which is usually a quick step, but make sure the card reader is installed securely.
# install ETC card reader
The ETC reader is usually installed on the inside of the vehicle's front windshield, near the car's rearview mirror. The installation location should be selected in an area that is less vulnerable to direct sunlight and does not affect the driver's line of sight. The following are the installation steps:
oneCrashandburnps2. Clean the installation area on the inside of the windshield to ensure it is dust-free.
two。 Remove the back film of the adhesive tape and secure the ETC card reader to the windshield.
3. Adjust the angle of the card reader to make sure the reader is facing the sensor passing through the highway toll station.
4. Connect the ETC card reader to the vehicle power supply to ensure that the card reader is working properly.
# activate ETC device
After the installation is complete, you need to activate the ETC device. This step usually needs to be done by the car owner himself, as follows:
-insert the ETC card into the card slot of the card reader.
-follow the prompts on the reader screen to complete the device activation.
-if you have any questions, you can call ETC customer service for advice.
# testing ETC function
After the ETC device is installed and activated, the car owner should conduct a test to ensure that the ETC is working properly. The test method is as follows:
-drive through the ETC lane of the highway.
-pay attention to the traffic lights and monitors. Normally, when the vehicle passes, the signal lights should be green and the display screen will show the success of the transaction.
# points for attention
-ensure that the ETC card reader is not blocked so as not to affect the transmission of electronic payment signals.
-check the balance in the ETC card regularly to ensure that the balance is sufficient to avoid non-payment.
-when the vehicle is transferred or the vehicle information is changed, the ETC equipment information should be updated in time to avoid problems in use.
Through the above steps, car owners can successfully install ETC for their vehicles and enjoy the convenience brought by ETC. At the same time, the use of ETC also helps to reduce the traffic pressure on the highway and improve the efficiency of road use.
Step content Note 1 preparation work to ensure complete materials, read processing flow 2 to obtain ETC equipment to select a suitable card reader, pay attention to installation requirements 3 install ETC card reader installation location should be reasonable, ensure that it does not affect the line of sight 4 activate ETC device to complete activation 5 test ETC function through ETC lane observe signal light and display screen according to card reader screen prompt